Purite Integra E+
Purite Integra E+
For hospital sterile services and endoscopy units
Type I, II or III water / RO water / Deionised (DI) water / Ultrapure water (UPW) water
The Purite Integra E+ uses proven reverse osmosis technology in conjunction with dechlorination and particle filtration as part of the first stage of the purification process. The purified water from this first stage is stored in an integral stainless steel tank before being circulated via a ring main. To maintain microbiological control of the system, the circulating water is continually purified by passing it through a 0.2 micron filter and then irradiated with ultra-violet light at a germicidal wavelength of 254nm.
Overview:
The system requires a softened feed water and has been developed specifically to meet the requirements of the latest decontamination guidelines for final rinse water. It features thermal sanitisation, which can be set to sanitise automatically to a pre-programmed time or on demand.
As standard, Purite Integra E+ is equipped with integral data logging technology, which facilitates capture of all key operating parameters, including alarm states, water quality and system performance, thus providing a permanent record of operation – essential for validation history.
Features:
- Completely self-contained in a robust housing that is easy to clean, maintain and transport
- Minimal installation and commissioning
- Integral, fully drainable 250 litre, stainless steel storage tank and bacterially protected to comply with HTM 01-06
- Integral raw water break tank with backflow protection
- BMS alarm output connection
- Panel mounted, backlit, LCD display
- Data logging of critical parameters
- Automatic hot water sanitisation cycle
- Semi-automatic membrane cleaning cycle
- Hygienic, sanitisable, stainless steel bio-sample valve on outlet
- Auto ringmain flush available for temperature control
- Leak detection system incorporated
- Can supply ring mains of potentially up to 200 metres (application and site dependent).
Tech Specs
| Unit specification | Integra E+ |
|---|---|
| Width (mm) | 1000 |
| Depth (mm) | 750 |
| Height (mm) | 1800 |
| Maximum Shipping Weight (kg)* | 372 |
| Maximum Working Weight (kg)* | 622 |
| Installation requirements | Integra E+ |
|---|---|
| Power | 400V ±10%+N+E, 50Hz, 3ph |
| Minimum inlet pressure – psi (bar) | 43.5 (3) |
| Maximum inlet pressure – psi (bar) | 87 (6) |
* Includes packing case
| Treated water specification | Integra E+ |
|---|---|
| Feedwater temperature (°C) | 1-30 |
| Feedwater hardness (ppm CaCO3) | < 4 |
| Feedwater pressure (bar) | 3-6 |
| Feedwater consumption (max l/hr) | 1000 max |
| Drain flowrate | 300 |
| Pure water recovery (max %) | 70 |
| Make up flow rate @ 10ËšC (l/hr) | 600 |
| Purified water output | 1,000 l/hr at 4 bar to 3,000 l/hr at 2.5 bar |
| Pure water storage | 250 |
| Purified water quality | Integra E+ |
|---|---|
| Conductivity | < 30µS/cm |
| Total viable count | < 10cfu/100ml |
| Endotoxin | < 0.25EU/ml |
| Silica | < 0.2 mg/l |
